项目编号：mcuclub-jj-017
仿真连接：点击跳转
51实物链接：点击跳转
32实物链接：点击跳转
51设计说明书链接：点击跳转
字数：15000+
摘要
本设计基于AT89C52单片机作为空调温度控制系统的检测和控制核心，通过DS18B20测量温度，在制冷模式中，如果温度高于设置最大值，则启动制冷继电器制冷；在制热模式中，如果温度低于设置最小值，则启动制热继电器制热。以此来完成驱动系统加热工作或者完成驱动系统制冷工作。本设计充分利用了单片机价格低、功能强、抗干扰性能好等优点。针对环境温度检测给出了实用的硬件设计和软件编程，成功实现了控制器对空调的智能控制，通过显示屏显示测量值及模式等。整个装置使用红外接收头和遥控器，可控制空调。
关键词：单片机 空调控制 温度采集 传感器；
Abstract
This design is based on AT89C52 single chip microcomputer as the detection and control core of the air conditioning temperature control system. The temperature is measured through DS18B20. In the refrigeration mode, if the temperature is higher than the set maximum value, the refrigeration relay is started for refrigeration; In heating mode, if the temperature is lower than the set minimum value, start the heating relay for heating. This is used to complete the heating work of the drive system or the cooling work of the drive system. This design makes full use of the advantages of low price, strong function and good anti-interference performance of single-chip microcomputer. The practical hardware design and software programming are given for the ambient temperature detection. The intelligent control of the controller to the air conditioner is successfully realized, and the measured value and mode are displayed on the display screen. The whole device uses an infrared receiver and a remote controller to control the air conditioner.
Key words: Single chip air conditioning control temperature acquisition sensor;
目录
摘要
Abstract
第一章 绪论
第二章 系统设计方案
第三章硬件设计
第四章软件设计
第五章 仿真测试
第六章 实物测试
第七章 结论
参考文献
附录
……………..本设计说明书是配套实物和仿真的，完整的设计参考书请购买后下载，购买过程遇到任何问题请联系客服进行咨询。本资料是一次性商品，不支持退货，感谢您对单片机俱乐部的支持……………..